TBSDTV Community Forum

Hello,

I have two problems,
AD1 - can not be upgraded via microSD, after reboot no change.
Of course, the poison of your procedure. I have a 2GB microSD card.
You can update manually via SSH? Please advice how to do it.

AD2 - without CAM module MOI find all my channels, but when you insert the CAM does not find anything or even free channels freeze.
In our area we have CAM IRDEO - SKYLINK provider (CSLink).
Please advice.

Thank you and best regards.
Honza

jtrefil Wrote:Hello,

I have two problems,
AD1 - can not be upgraded via microSD, after reboot no change.
Of course, the poison of your procedure. I have a 2GB microSD card.
You can update manually via SSH? Please advice how to do it.

Yes, i had a some problem (but I have an 8G card).
1. Connect MOI with PC
2. Stop, when booting.
3. Put:
fdisk -c 0

after procedure control with:
fdisk -p 0

(output must be something like:
partion # size(MB) block start # block count partition_Id
1 6972 1249680 14279880 0x0C
2 126 30480 259080 0x83
3 364 289560 746760 0x83
4 104 1036320 213360 0x83
)

3. Put:
fatformat mmc 0:1

3. Insert formated card to PC with files for MOI (kernel/rootfs) and copy it to card.
4. Insert card back to MOI
5. Type:
reset

Note: this isn't result of problem.

jtrefil Wrote:AD2 - without CAM module MOI find all my channels, but when you insert the CAM does not find anything or even free channels freeze.
In our area we have CAM IRDEO - SKYLINK provider (CSLink).
Please advice.

Thank you and best regards.
Honza

What type of CAM? (Neotion nCam - some problem)

TVheadend don't working
DVBApps Utils - don't working (scan, etc).
MumuDVB - working with wrong initialisation of CI (Updater), so only fta.
DVBlast - right init, but pixelations when streaming begin, without known reason.

But this CI module need a higher TS Clock and some apps need a bigger DVR Buffer.
And drivers are precompiled...
You'll see, how much is needed for properly using.

Hi,

thank you very much for your answer.

I'm sorry but I do not have much experience, connect to the MOI is meant by RS232 or SSH?
On the RS232 connections need special cable or any regular RS232?

I have two CAM, from TechniSat TechniCrypt CW and from SMIT IRDETA CI +.
The access card SKYLINK IRDETO - freezes with both CAM.

Thank you very much for your help.
Sincerely,
Honza

jtrefil Wrote:Hi,

thank you very much for your answer.

I'm sorry but I do not have much experience, connect to the MOI is meant by RS232 or SSH?
On the RS232 connections need special cable or any regular RS232?

I have two CAM, from TechniSat TechniCrypt CW and from SMIT IRDETA CI +.
The access card SKYLINK IRDETO - freezes with both CAM.

Thank you very much for your help.
Sincerely,
Honza

Over cross RS232.
About CI module, You have a PM.