TBSDTV Community Forum

When I change channel which is on other multiplex than previously in kern.log I have messages without message:

Code: Select All Code

Oct  8 13:35:16 XBMCLive kernel: [  270.690184]
Oct  8 13:35:17 XBMCLive kernel: [  271.862435]
Oct  8 13:35:28 XBMCLive kernel: [  283.242154]
Oct  8 13:35:30 XBMCLive kernel: [  284.746425]
Oct  8 13:35:32 XBMCLive kernel: [  287.006455]


Somtimes, when i watch channel A picture stop and i must switch to channel B from other multiplex for a while and back to A to be well. If I did not switch to channel B i get a message of bad signal.


Previously I had 6921 and all was ok. Signal strength and quality is the same.

I use:
last tvheadend (c88a646)
ubuntu 10.04 with linux-image-2.6.32-33-generic
linux-tbs-drivers_110928.zip

Thanks for the reply.

Hi zibzib

when i watch channel A picture stop and i must switch to channel B from other multiplex for a while and back to A to be well. If I did not switch to channel B i get a message of bad signal.

this is because if you change B to A ,it will lock again,if you do not change it will not lock again,so i think if you use XBMC to lock channel A again,
it maybe ok,you can have a try.

Thanks

The second problem happens on Hotbird 13E,11393 V,DVB-S,SR 27500,FEC 5/6 channels "TVN...".
If I use xbmc+tvheadend or only tvheadend is the same problem

What about the first problem?

Today I installed drivers linux-tbs-drivers_111013.zip and first problem was gone, but only first.