TBSDTV Community Forum

Hi,

I'm using TBS5922 Card on Windows 7 32 bit (Ultimate Edition - Fully Updated). I installed Latest Drivers from Site and the Box works without problem with DVBdream.But when i tried to set it up in Windows Media Center 7,i received no Signal. I have a switch and 2 Universal Ku LNBs on Port 2 & 3. i configured them and when i try to scan (Single or Full trasponder Scan - doesn't matter) it finds nothing (No signal).

Does any one has any solution for This?

Hello again,

Update
After restarting windows , there wa some sort of improvement : (I use a 4-port switch with NileSat on Port 2 & Hotbird on Port 3 . I should say again : in ProgDVB & DVBdream there is no problem.)

i used single Transponder scan and used the Best Transponder in Nilesat (according to Signal Power & quality in dvbdream). when i entered the FREQ , Synbol Rate and polarization, and waited 2 seconds,it showed a green bar "(Singnal Qaulity) and lock indicator on the unit was ON. but it wasn't stable ,after 1 second lock indicator started to blink and the Signal Quality bar started to jump between green and yellow . i hit the Next to start scan , Lock indicator was ON (Green LED on the box)and stable , but no channels found. i think there is some sort of Communication Problem between WMC and the Box.

there also "might" be a problem with 64 bit drivers as well. but only with windows 7 version. I got this as soon as it was available.
Not long after install i started getting blue screens. So resinstalled windows from scratch. Same problem kept re-occuring for me.

So i instead switched to 32Bit vista , only had problems with dvbdream since. Now i just need to find a program what will work with the remote without having to figure out winrc.
It may be a problem related to my motherboard not being normal ( asus E35M1M_PRO) , but since it's stable on vista i doubt that at all.

hope this helps
chris

CasioJones Wrote:there also "might" be a problem with 64 bit drivers as well. but only with windows 7 version. I got this as soon as it was available.
Not long after install i started getting blue screens. So resinstalled windows from scratch. Same problem kept re-occuring for me.

So i instead switched to 32Bit vista , only had problems with dvbdream since. Now i just need to find a program what will work with the remote without having to figure out winrc.
It may be a problem related to my motherboard not being normal ( asus E35M1M_PRO) , but since it's stable on vista i doubt that at all.

hope this helps
chris

Hi ,

I'm using Windows 7 Ultimate 32bit version ,so i'm not using 64 bit drivers.

Hi
Would mind try new Driver.you can download on our download page. version:2.0.1.5
Thanks

re-installing windows as we speak , should have feed back in a day or 2 with i try different versions of windows.

Ty
Chris

CasioJones Wrote:re-installing windows as we speak , should have feed back in a day or 2 with i try different versions of windows.

Ty
Chris

Hi CasioJones
Is it ok now ?
thanks

sorry for not updating since , other r/l problems distracted me.
from the looks of it - it's all good now.
Ty for the help

I have exactly the same problems with the current Version V2.0.2.1.
After going back to the version that was on my CD (V2.0.1.6) it works now.

Same issue here. Low or no signal with latest TBS driver version. The driver on the CD (v 2.0.1.6)works well with DVBdream. It cannot do diseqc 1.0 switching for ProgDvb. I cannot use Windows Media Centre. I'm on Win7 32 bit.