Page 1 of 1
dvblast udp problem
Posted:
Tue Feb 21, 2012 6:38 pmby aerayp
Hello,
I use tbs6984 board to get satellite streams and dvblast to send streams to multicast network. Unfortunately with UDP protocol I have packet loss. RTP is not useful for my system. How to solve this problem?
Thanks,
Eray
Re: dvblast udp problem
Posted:
Wed Feb 29, 2012 8:34 pmby SergioDanielG
UDP protocol haven' t got flow control or error correction. If there are lossing packages maybe you have a poor signal conextion or low symbol rate. What about this?
Best regards.
Re: dvblast udp problem
Posted:
Sat Aug 18, 2012 9:32 pmby spacedvb
use getstream_84 download from cesbo dot com.
Re: dvblast udp problem
Posted:
Mon Aug 18, 2014 7:15 amby ahmedramze
dvblast -u -a 1 -f 10890000 -s 27500000 -v 13 -F 78 -m psk_8 -Y -U -d 239.0.0.1:1205
f- Frequency
s- symbol rate
-v LNB Voltage H=18 , V=13
-m modulation , qpsk , or psk_8 , QAM, etc.
-U mean udp with out -U will be RTP protocol (( this is your issue ))
-d the destination Multicast IP and port
Re: dvblast udp problem
Posted:
Fri Dec 23, 2016 3:30 amby krmlk
I have similar problem. For 1-2 Tranpordereverythin seems ok withdvblast udp but after adding more transporder lose many packets
Re: dvblast udp problem
Posted:
Fri Dec 23, 2016 11:40 amby steven
krmlk Wrote:I have similar problem. For 1-2 Tranpordereverythin seems ok withdvblast udp but after adding more transporder lose many packets
What about your net work environment when you test the transponder one by one if everyone are ok then should be your network issue
make sure 1Gbps
Re: dvblast udp problem
Posted:
Sat Dec 24, 2016 6:05 amby krmlk
all internal network already 1 Gbit also 2 LAN 1Gbit active. Every port on the Router using 1Gbit connection. All the cables cat6. Actually DVBlast is best multicast streamer IMO but because of this reason I should use unicast with mumudvb (doesnt work properly with m cards) and astra cesbo .( tvheadend is goo, too) but it is crashing very often