TBSDTV Community Forum

Hello

I need help, i try to do blindscan using a tbs 6925 but i dont know how to do this.
i've recompiled the driver following the instruction in other post, and everything ok, but when i try using a scan this don't work for me , i think i used a wrong command.
the other question is, to use blind scan i need setup lnb frecuency or something else?

Log from command grep:

[root@test bin]# dmesg | grep SAA716x
SAA716x TBS 0000:01:00.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
SAA716x TBS 0000:01:00.0: setting latency timer to 64
DVB: registering new adapter (SAA716x dvb adapter)

Best Regards from Panama

Hi wannabe.

Which software are you using to scan and how do you do it?

Best regards

hello, i m ussing scan-s2 to scan but the command table is too long and hard to undertand.
can u say me, how i do a blind scan using it ?

Thanks

Hi wannabe.
You must to understand scan-s2 options to use it. Why? Because your scan depends of your hardware. But if you have only one adapter, one tunner, no diseqc, no motor, universal lnb, you can ommit all parameters, and in this case you can run only "scan-s2 fileWithTransponderList.conf
You must to understand scan-s2 isn't an blinscan sofware.

Best regards

Thanks alot for your great support Sergio.
with your command i've solved my problem

Thanks