TBSDTV Community Forum

hi, I have buy this card for replace the old quad-tuner, only
because I need to record from more of 4 different mux.
from when I have buy this new card, I have never seen 1 dvb-t channel.
what to do ?
i'm angry to have spent 350 euro for see nothing.
i'm ready for send back the card and ask for the money.
thank.

Hi

For the 6209 what about the signal input is the loopout signal from 6205 ? please have a try direct put the signal to 6209 check whether is ok

thanks

Kind Regards

steven

SAME here , Everything is ok Hardware it is recognized , BUT NO SIGNAL and ZERO CHANNELS AFTER SCAN

I set TBS6209 Change Mode Tool v1.0.0.1 to DVB-T2 write and it recognize it BUT NO CHANNELS FOUND and NO SIGNAL after SCAN

Maybe need some amplifier ? RF signal splitted btw 8 tuners.

SJGSM Wrote:SAME here , Everything is ok Hardware it is recognized , BUT NO SIGNAL and ZERO CHANNELS AFTER SCAN

I set TBS6209 Change Mode Tool v1.0.0.1 to DVB-T2 write and it recognize it BUT NO CHANNELS FOUND and NO SIGNAL after SCAN

Hi

we already fixed unottico1965 issue can you send one email to my email steven@tbsdtv.com we will have a remote check where the problem is
as we need more detail information .

Thanks

Kind Regards

steven

I have the exact same problem. Tuner can't find any channels dispite knowing the ariel is good.
I tried to contact support but nobody replied.

Is there a fix?

Hi darrensellers

We have not get email for you ,can you tell us that which email you send to ? and already send a test driver please have a check
and test whether is good

Thanks

Kind Regards

steven

I completed the online support form. I tried the new driver, but still the same. The change mode tool also doesn't work I get the error "QuerySupported KSPROPERTY_BDA_CTRL_DemodMode Error"

darrensellers Wrote:I completed the online support form. I tried the new driver, but still the same. The change mode tool also doesn't work I get the error "QuerySupported KSPROPERTY_BDA_CTRL_DemodMode Error"

Here's what you need to do:uninstall the driver and then install it again,as you can see in the picture.Hope to help.
I am using driver version 1.0.0.2 - 27-Dec-16.

I uninstalled and reinstalled the driver. The switch tool now works, but the tuner still doesn't find any channels.