TBSDTV Community Forum

hello i buy a tbs 6903 tv card，but it can not work in DiseQC1.1，
it do not spoort diseqc1.1？ths

Hi

Which application you used with 6903 ? linux or windows ? as our card driver in linux and window both have the Diseqc interface so
just check whether the application added support

Thanks

Kind Regards

steven

Hi
steven
i use windows10 64bit card driver is 1.0.0.1，so i can use the DiseQC1.1 in EBSbillscan，but it can work in TransEdit and Dvbviewer，it only have single in LNB1.

Ths

Hi liang, I have the same issue with Dvbviewer and Tbsviewer using the tbs 6902 card. Diseqc commands don't work. I downloaded the trial version of Dvbdream 2.81 and the diseqc commands worked fine. This might be worth a try for you to see if diseqc commands are working with your card. I don't know what EBSbillscan is......maybe there is an update available....Duane

hi
duane01098
i know tbs 6903 can work in dvbdream with DiseQC1.1?,but i like dvbviewer and TransEdit,EBSbillscan is EBSpro my English is not good sorry.

Ask DVBViewer/Transedit authors about DiseqC support.

liang747 Wrote:hi
duane01098
i know tbs 6903 can work in dvbdream with DiseQC1.1?,but i like dvbviewer and TransEdit,EBSbillscan is EBSpro my English is not good sorry.

Here's how to configure TransEdit and DVBViewer for Diseqc 1.1 .In the example below I chose lnb 7 for Astra 3B from 23.5 E of 16 LNBs for a toroidala dish.
Everything works fine if set correctly each lnb in TransEdit and than check Channel Editor .

hi
satesco
can you send me the TransEdit V.4.1.1.0? Email：serlimon@163.com
i think i use V4.0.1.0 is not support DiseQC2.x，and what Switch do you use？
THANK YOU

Hi liang747,

I sent the requested version to your email. I hope to help you, but I have to add that I've worked with previous versions of TransEdit and had no problems with diseqc 1.1. I think more important than the version used,is to properly configure the switch 1.1 in TransEdit! With EMP-Centauri switch 17in/1out 1.1&1,I haven't had problems since 2008 when I use it.
Regards

hi satesco
i uesd ransEdit V.4.1.1.0 but it can not work “Analyze”？