TBS 6909X V2 NORMAL MODE=1

[achilless]

Hello dear users.

my configuration is like this
quattro lnb to multiswitch and then tbs6909x

6909x works only mode=1 but problem is here.

every tuner must be work like this
If adapter0 VL then adapter1 must be VL
If adapter0 VL then adapter1 VH ( it does not work )

my question is every two tuner has to be work with Vertical or Horizantal ? ninstead of Low-band or High-band ?

[crazycat]

Every two tuner work in same polarization (same LNB voltage) and band (continous 22KHz tone)

I your case better use mode=0 (default mode) if only one LNB connected to multiswitch (or direct quattro/quad LNB connection to card)

[achilless]

I have multiswitch 17/40 with quattro lnb VL VH HL HH
At this configuration i can choose 4 satellites by diseqc.

i choose mode-0 ( signal faild )
i choose mode-1 only works like this

For example

If adapter-0 —> VL then adapter-1 has to be —> VL
How can i get signal on every two adapter no matter band it is low or high ?

In this example it did not work

Adapter-0 —> VL
adapter-1 —> VH

How to use like this ?

[crazycat]

mode 0 not pass diseqc cmd, so only first LNB accessible